Running Laboratory Experiments Via The World Wide Web Article Swipe
YOU?
·
· 2020
· Open Access
·
· DOI: https://doi.org/10.18260/1-2--7395
· OA: W2756489422
NOTE: The first page of text has been automatically extracted and included below in lieu of an abstract 3513 Running Laboratory Experiments via the World Wide Web Jim Henry The University of Tennessee at Chattanooga Abstract The chemical engineering laboratories at the University of Tennessee at Chattanooga have been made available for students to use via the World Wide Web. Students can conduct lab experiments from remote sites. This paper describes the hardware and software that is used for this facility and discusses strengths and "opportunities for improvement" that have been observed in this development. The web address for the lab is http://chem.engr.utc.edu. Hardware and Software The chemical engineering laboratories have been using desktop computers for data acquisition and control of engineering equipment since 1990. The students conduct experiments to observe steady-state and transient operating performance, accomplish system identification and, in some cases, design feedback controllers for the systems. The data acquisition and control software is written with LabVIEW software (from National Instruments, http://www.natinst.com ). Controller design, if done, involves tuning two feedback controllers: a proportional controller and a proportional-integral controller. The computers are all networked with ethernet and have internet (IP) addresses. A web-server program was developed which allows students to conduct experiments using widely available web browsers. The students conduct the experiments either from computer labs on campus or from remote computers via the world wide web. Hardware Stations The controls labs and some unit operations experiments are web-accessible. Seven different stations for controls systems experiments and an additional seven stations for unit operations experiments are available. They are listed in Table 1.
