Abstract The Compact Linear Collider (CLIC) is a TeV-scale high-luminosity linear e + e − collider studied by the international CLIC and CLICdp collaborations hosted by CERN. CLIC uses a two-beam acceleration scheme, in which normal-conducting high-gradient 12 GHz accelerating structures are powered via a high-current drive beam. For an optimal exploitation of its physics potential, CLIC is foreseen to be built and operated in stages. The initial stage will have a centre-of-mass energy of 380 GeV, with a site leng…

The staging scenario for CLIC has been updated following new studies of the beam emittance through the accelerator chain, which has resulted in higher expected luminosities, and a change in baseline to a 100 Hz repetition rate at the initial energy stage. Here, the Higgs coupling sensitivities are updated for the new staging plan.

In order to stimulate new engagement and trigger some concrete studies in areas where further work would be beneficial towards fully understanding the physics potential of an $e^+e^-$ Higgs / Top / Electroweak factory, we propose to define a set of focus topics. The general reasoning and the proposed topics are described in this document.

Abstract The High Granularity Timing Detector (HGTD) will be installed in the ATLAS experiment to mitigate pile-up effects during the High Luminosity (HL) phase of the Large Hadron Collider (LHC) at CERN. Low Gain Avalanche Detectors (LGADs) will provide high-precision measurements of the time of arrival of particles at the HGTD, improving the particle-vertex assignment. To cope with the high-radiation environment, LGADs have been optimized by adding carbon in the gain layer, thus reducing the acceptor removal rat…

Abstract The High Granularity Timing Detector for the ATLAS upgrade is under construction to meet the challenges of the HL-LHC. In order to connect a module, the basic detector element, to the surrounding peripheral electronic board, a flexible printed circuit (FPC) is used as an interconnection for data transmission and power distribution. An identical design for all FPCs is required except for their length, depending on the module position on the detector active area. The design and qualification of a preliminar…