Peter Y. Hsieh
YOU?
Author Swipe
View article: Thermophysical modeling of raw glaze liquidus temperature and viscosity
Thermophysical modeling of raw glaze liquidus temperature and viscosity Open
Raw glazes, which do not contain pre‐melted glass frits, are widely used due to their low cost. The natural variability of the mineral compositions used in raw glazes affects their viscosity during firing. Molten glaze viscosity plays an i…
View article: Optical Metrology for Near-Net-Shaped Additively Manufactured Ceramic Components
Optical Metrology for Near-Net-Shaped Additively Manufactured Ceramic Components Open
Optical Metrology for Near-Net-Shaped Additively Manufactured Ceramic Components presented at the 45th International Conference and Exposition on Advanced Ceramics and Composites
View article: Use of Commercial Off-The-Shelf Parts with 3-D Printed Connectors for Powered Air Purifying Respirators
Use of Commercial Off-The-Shelf Parts with 3-D Printed Connectors for Powered Air Purifying Respirators Open
This report presents preliminary results from the performance evaluation of a powered air purifying respirator (PAPR) assembled from commercial off-the-shelf (COTS) parts. Cost is a major limiting factor to PAPR adoption in healthcare. Mor…
View article: Effects of temperature non‐uniformity and effective viscosity on pyrometric cone deformation
Effects of temperature non‐uniformity and effective viscosity on pyrometric cone deformation Open
Pyrometric cone deformation is used to measure heat work or the combined effect of temperature and time during ceramic firing. Finite‐element analysis shows that stationary‐state temperature non‐uniformity in a pyrometric cone during const…
View article: Investigation of heat transfer associated with support structures in large glass walls
Investigation of heat transfer associated with support structures in large glass walls Open
The heat transfer characteristics of window glass panes, supported by mullion structures, are considered. Windows usually consist of approximately 85% glass and 15% supporting structures by area. However, because supporting structures may …