Marina Terlau
YOU?
Author Swipe
View article: In-process analysis of the dynamic deformation of a bionic lightweight gear
In-process analysis of the dynamic deformation of a bionic lightweight gear Open
View article: Contributions to increasing the accuracy and reducing the forming forces of robot-based two-point incremental forming
Contributions to increasing the accuracy and reducing the forming forces of robot-based two-point incremental forming Open
This article presents the latest research results on the enhancement of robot-based incremental sheet metal forming performance in detail and comprehensively. Since the low robot stiffness leads to deformations of the robot and thus deviat…
View article: Tool pose measurement using shadow imaging sensors
Tool pose measurement using shadow imaging sensors Open
Due to the high positioning uncertainty and low stiffness of robots, significant geometrical deviations occur in robotic incremental sheet forming (ISF) which requires an optical in-process tool pose measurement. To achieve a measuring unc…
View article: Optical tool deflection measurement approach using shadow imaging
Optical tool deflection measurement approach using shadow imaging Open
In incremental sheet forming, geometrical deviations occur due to deflections of the forming stylus. To compensate the deviations, a non-contact in-process tool deflection measurement is required that is capable of measuring the tool tip p…
View article: Shadow-Imaging-Based Triangulation Approach for Tool Deflection Measurement
Shadow-Imaging-Based Triangulation Approach for Tool Deflection Measurement Open
As incrementally formed sheets show large geometric deviations resulting from the deflection of the forming tool, an in-process measurement of the tool tip position is required. In order to cover a measuring volume of 2.0 m × 1.0 m × 0.2 m…
View article: Optische Messung der Werkzeugablenkung in der inkrementellen Blechumformung
Optische Messung der Werkzeugablenkung in der inkrementellen Blechumformung Open
Zusammenfassung Zum Umformen großer Bleche in kleinen Stückzahlen stellt die inkrementelle Blechumformung eine wirtschaftliche Alternative zum Tiefziehen dar. Auftretende Werkzeugablenkungen führen jedoch zu erhöhten Formabweichungen. Mit …
View article: P22 - Validation of an Inside Sensor System for Deformation Measurements on Bionic Lightweight Gears
P22 - Validation of an Inside Sensor System for Deformation Measurements on Bionic Lightweight Gears Open
View article: Active Thermography for the Detection of Sub-Surface Defects on a Curved and Coated GFRP-Structure
Active Thermography for the Detection of Sub-Surface Defects on a Curved and Coated GFRP-Structure Open
Initial defects, for example, those occurring during the production of a rotor blade, encourage early damages such as rain erosion at the leading edge of wind turbine rotor blades. To investigate the potential that initial defects have for…