Feng‐Min Lai
YOU?
Author Swipe
View article: Graphite emulsion with excellent dispersion stability and rheological property for drawing ultrafine tungsten wire
Graphite emulsion with excellent dispersion stability and rheological property for drawing ultrafine tungsten wire Open
The development of silicon wafers in the photovoltaic industry towards larger and thinner sizes requires ultrafine tungsten wires, and the uniform coating of high-performance graphite emulsion is the key to ensuring the quality of tungsten…
View article: Graphite Emulsion with Excellent Dispersion Stability and Rheological Property for Drawing Ultrafine Tungsten Wire
Graphite Emulsion with Excellent Dispersion Stability and Rheological Property for Drawing Ultrafine Tungsten Wire Open
View article: The Enhanced Performance of Oxide Thin-Film Transistors Fabricated by a Two-Step Deposition Pressure Process
The Enhanced Performance of Oxide Thin-Film Transistors Fabricated by a Two-Step Deposition Pressure Process Open
It is usually difficult to realize high mobility together with a low threshold voltage and good stability for amorphous oxide thin-film transistors (TFTs). In addition, a low fabrication temperature is preferred in terms of enhancing compa…
View article: Dielectric properties of hafnium oxide film prepared by HiPIMS at different O2/Ar ratios and their influences on TFT performance
Dielectric properties of hafnium oxide film prepared by HiPIMS at different O2/Ar ratios and their influences on TFT performance Open
High-k hafnium oxide (HfO2) film was prepared by high power impulse magnetron sputtering (HiPIMS). The influences of oxygen supply on the plasma state, film properties and TFT performance were investigated. The films are near-stoichiometri…
View article: Development of Physical Vapor Deposition Technique and Testing on Ceramics and CoCrMo Alloys
Development of Physical Vapor Deposition Technique and Testing on Ceramics and CoCrMo Alloys Open
In this study, TiN thin films were coated on CoCrMo alloys and ceramic samples using vacuum coating technology with high-power impulse magnetron sputtering (HiPIMS), which was followed by coating at 100 and 200 °C to a thickness of 250, 50…
View article: Crystal phase control of copper oxide thin films by process pressure during high power impulse magnetron sputtering
Crystal phase control of copper oxide thin films by process pressure during high power impulse magnetron sputtering Open
High-performance P-type cuprous oxide (Cu2O) film was prepared at room temperature by high power impulse magnetron sputtering. Optical emission spectra revealed that the ratio of Cu radicals/ions in the plasma significantly decreased with …
View article: Superior Performance of ZnGaO Solar-Blind Photodetectors by Implementing TFT Structure and Tunable ZNO Cycle Ratio
Superior Performance of ZnGaO Solar-Blind Photodetectors by Implementing TFT Structure and Tunable ZNO Cycle Ratio Open
View article: Investigation of Amorphous (in X Ga1- X )2o3 Alloy Films Modulated by Indium Content for Optimization in Solar-Blind Photodetector
Investigation of Amorphous (in X Ga1- X )2o3 Alloy Films Modulated by Indium Content for Optimization in Solar-Blind Photodetector Open
View article: Investigation of Low Temperature Amorphous (in X Ga1- X )2o3 Films Modulated by Indium Content for Optimization in Solar-Blind Photodetector
Investigation of Low Temperature Amorphous (in X Ga1- X )2o3 Films Modulated by Indium Content for Optimization in Solar-Blind Photodetector Open
View article: Plasma power effect on crystallinity and density of AlN films deposited by plasma enhanced atomic layer deposition
Plasma power effect on crystallinity and density of AlN films deposited by plasma enhanced atomic layer deposition Open
Aluminum nitride (AlN) film is a promising material which is used in various fields. In this study, AlN films with different plasma powers were grown by remote plasma atomic layer deposition. Saturation experiments have been applied in the…
View article: Internal moisture barrier layer for improving high-humidity reliability of miniature light emitting diode die without encapsulation
Internal moisture barrier layer for improving high-humidity reliability of miniature light emitting diode die without encapsulation Open
Atomic layer deposited Al 2 O 3 films are incorporated into miniature light emitting diodes (mini-LEDs) as an internal moisture barrier layer. The experimental results show that the water vapor transmission rate reaches ≤10 −4 g/m 2 /day w…
View article: Ultrafast RTA induced the structural properties of the deficient oxygen β-Ga2O3 film
Ultrafast RTA induced the structural properties of the deficient oxygen β-Ga2O3 film Open
The RF-sputtered β-Ga2O3 films prepared on sapphire substrates were treated by rapid thermal annealing (RTA) with an ultrafast processing time of 30 s. The effects of RTA at different process temperatures from 600 to 800 °C on the β-Ga2O3 …
View article: Plasma Power Effect on Crystallinity and Density of Peald-Aln Thin Films： Toward Increasing Dielectric Constant and Breakdown Electric Field
Plasma Power Effect on Crystallinity and Density of Peald-Aln Thin Films： Toward Increasing Dielectric Constant and Breakdown Electric Field Open
View article: Effect of Al/Ga Elemental Ratio on Properties of Alxga1-Xn Films Using Super-Cycle Plasma Enhanced Atomic Layer Deposition
Effect of Al/Ga Elemental Ratio on Properties of Alxga1-Xn Films Using Super-Cycle Plasma Enhanced Atomic Layer Deposition Open
View article: Cu-Doped Lithium Oxide Films with High Mobility and Bandgap Prepared by Pulsed Direct-Current Sputtering
Cu-Doped Lithium Oxide Films with High Mobility and Bandgap Prepared by Pulsed Direct-Current Sputtering Open
View article: Ultrafast RTA Induced the Structural Properties of the Deficient Oxygen Β-Ga2o3 Film
Ultrafast RTA Induced the Structural Properties of the Deficient Oxygen Β-Ga2o3 Film Open
View article: Antibacterial Ability of Alloy Materials Used in Surface Coating Techniques with Ag Films
Antibacterial Ability of Alloy Materials Used in Surface Coating Techniques with Ag Films Open
In response to increased attention to oral hygiene, materials of artificial dental implants and denture frameworks having antibacterial effects are increasingly valued.According to our literature review, most of the bacteria in the oral ca…
View article: Designing, Manufacturing, and Testing a Voice-controlled Intelligent Drawer
Designing, Manufacturing, and Testing a Voice-controlled Intelligent Drawer Open
In this study, a voice control model was assembled using Arduino UNO and LD3320 sensor modules, and this model was then used to create the voice control system for use in a smart drawer that could improve the convenience of daily life.We e…
View article: Fatigue Tests and Fracture Behavior Analysis of Porous Implant Materials Fabricated by 3D Metal Printing Technology
Fatigue Tests and Fracture Behavior Analysis of Porous Implant Materials Fabricated by 3D Metal Printing Technology Open
3D-printed Ti-6Al-4V materials can be used for implantation upon the confirmation of medical device specifications.Moreover, Young's coefficient of porous Ti-6Al-4V is close to that of the human bone, and it can allow the growth of bone ce…
View article: Effects of Sintering Temperature on Structural, Morphological, and Mechanical Properties of Co-Cr-Mo Alloys Coated with ZrO2 Ceramic Films
Effects of Sintering Temperature on Structural, Morphological, and Mechanical Properties of Co-Cr-Mo Alloys Coated with ZrO2 Ceramic Films Open
In this study, ZrO 2 thin films were coated on Co-Cr-Mo alloys by screen printing and spraying, which was followed by sintering at a high temperature of 750, 900, or 1100 °C to enhance the characteristics of the coated alloys.Through X-ray…
View article: Bending Mattress and Antibacterial Effect of TiO2/nAg/Chitosan-nanoparticle-applied Intelligent Patient Bed
Bending Mattress and Antibacterial Effect of TiO2/nAg/Chitosan-nanoparticle-applied Intelligent Patient Bed Open
In Taiwan, the hot and humid weather easily leads to a bedsore problem in bedridden patients.Moreover, general patient beds are inconvenient for elderly people with reduced mobility.In this study, to develop a biocompatible mattress that c…
View article: Mechanical Properties of Porous Ti?6Al?4V Alloys Prepared by Selective Laser Melting and Post-heat Treatments
Mechanical Properties of Porous Ti?6Al?4V Alloys Prepared by Selective Laser Melting and Post-heat Treatments Open
In this study, porous Ti-6Al-4V alloys were prepared by selective laser melting (SLM), and post-heat treatments were also performed on as-built alloys.The effects of post-heat treatments on the microstructural and textural properties of SL…
View article: Thermal, Optical, and Microstructural Properties of Magnetron Sputter-Deposited CuSi Films for Application in Write-Once Blu-Ray Discs
Thermal, Optical, and Microstructural Properties of Magnetron Sputter-Deposited CuSi Films for Application in Write-Once Blu-Ray Discs Open
In this study, 16-nm-thick CuSi films were deposited at room temperature by DC magnetron sputtering. The thermal, optical, and microstructural properties of CuSi films were investigated in detail. Moreover, the CuSi film was further used a…
View article: Improved Mechanical Properties of Al<sub>2</sub>O<sub>3</sub> Ceramics by Sputtered TiN Coatings
Improved Mechanical Properties of Al<sub>2</sub>O<sub>3</sub> Ceramics by Sputtered TiN Coatings Open
In this study, TiN thin films have been prepared as the coating layers on Al2O3 ceramic substrates to enhance the mechanical properties of Al2O3 ceramics. TiN films with various thicknesses of 0.5 and 1 μm were deposited by DC sputtering a…
View article: Recording Characteristics, Microstructure, and Crystallization Kinetics of Ge/GeCu Recording Film Used for Write-Once Blu-Ray Disc
Recording Characteristics, Microstructure, and Crystallization Kinetics of Ge/GeCu Recording Film Used for Write-Once Blu-Ray Disc Open
A Ge67Cu33 (16 nm) layer and a Ge (3 nm)/Ge67Cu33 (16 nm) bilayer were grown by sputtering at room temperature and used as the recording films for write-once blue laser media. In comparison to the crystallization temperature of Ge in a GeC…
View article: Thermal Stresses Analysis and Optimized TTP Processes to Achieved CNT-Based Diaphragm for Thin Panel Speakers
Thermal Stresses Analysis and Optimized TTP Processes to Achieved CNT-Based Diaphragm for Thin Panel Speakers Open
Industrial companies popularly used the powder coating, classing, and thermal transfer printing (TTP) technique to avoid oxidation on the metallic surface and stiffened speaker diaphragm. This study developed a TTP technique to fabricate a…
View article: Characterization of Al-Doped ZnO Transparent Conducting Thin Film Prepared by Off-Axis Magnetron Sputtering
Characterization of Al-Doped ZnO Transparent Conducting Thin Film Prepared by Off-Axis Magnetron Sputtering Open
The off-axis sputtering technique was used to deposit Al-doped ZnO (AZO) films on glass substrates at room temperature. For the illustration of the sample position in the sputtering chamber, the value ofis introduced. Here,is the radius of…
View article: <scp>HKUA</scp> Abstracts
<span>HKUA</span> Abstracts Open
Objective: We are reporting the management outcome of a prospective cohort of patients from a dedicated centre treating ketamine-associated uropathy.Patients & Methods: All patients who attended our centre for ketamine related urological p…