Yao‐Yang Tsai
YOU?
Author Swipe
View article: Induction heating ferromagnetic particles embedded PDMS mold for microstructure embossing
Induction heating ferromagnetic particles embedded PDMS mold for microstructure embossing Open
Polydimethylsiloxane (PDMS) is an excellent soft mold material with the advantages of precise replication, easy demolding, and low production cost. However, the strength and hardness of PDMS are relatively low, and PDMS cannot be directly …
View article: Grey-Taguchi-Based Optimization of Wire-Sawing for a Slicing Ceramic
Grey-Taguchi-Based Optimization of Wire-Sawing for a Slicing Ceramic Open
Slicing ceramic (SC) is well-known as difficult-to-cut material. It is a hard and brittle material. The Grey-Taguchi method, which converts multiple response problems into a single response, is used to determine the effect of the process p…
View article: The Effects of Different Slurry Concentrations and Wire Speeds for Swinging and Non-Swinging Wire-Saw Machining
The Effects of Different Slurry Concentrations and Wire Speeds for Swinging and Non-Swinging Wire-Saw Machining Open
Slurry concentration and wire speed affect the yield and machining quality of ceramics (Al2O3) that are produced using wire-saw machining (WSM). This study determines the effect of slurry concentration and wire speed on the material remova…
View article: Slicing Ceramics on Material Removed by a Single Abrasive Particle
Slicing Ceramics on Material Removed by a Single Abrasive Particle Open
Multi-wire saw machining (MWSM) used for slicing hard-brittle materials in the semiconductor and photovoltaic industries is an important and efficient material removal process that uses free abrasives. The cutting model of single-wire saw …
View article: Theoretical Derivation and A Single Abrasive Particle on Material Removed of Slicing Ceramic
Theoretical Derivation and A Single Abrasive Particle on Material Removed of Slicing Ceramic Open
Multi-wire saw machining (MWSM) used for slicing hard-brittle materials in semiconductor, is an important material removal process that uses free abrasives. Cutting model of single-wire saw machining (SWSM) is the basis of MWSM, and the ma…
View article: Improving Machining Efficiency Methods of Micro EDM in Cold Plasma Jet
Improving Machining Efficiency Methods of Micro EDM in Cold Plasma Jet Open
This paper investigates the characteristics of micro electrical discharge machining (EDM) in cold plasma jet using transistor pulse generator. In order to improve the processing efficiency and quality in stable process conditions, oxygen-a…