Yonggang Deng
YOU?
Author Swipe
View article: Numerical simulation design and optimization of regional cathodic protection in a large oil and gas station
Numerical simulation design and optimization of regional cathodic protection in a large oil and gas station Open
Introduction With increasing attention from both national authorities and the oil and gas industry to corrosion protection, regional cathodic protection (CP) design and optimization have become essential for ensuring the safe operation of …
View article: Application of composite layered repair system using titanium mesh, bone cement and vacuum sealing drainage for chest wall defect
Application of composite layered repair system using titanium mesh, bone cement and vacuum sealing drainage for chest wall defect Open
Objective To evaluate the therapeutic efficacy of a composite layered repair system utilizing titanium mesh (TM), bone cement (BC) and vacuum sealing drainage (VSD) for chest wall defect reconstruction, providing a reliable theoretical fou…
View article: A Comprehensive Study of the Effect of Lubricant in the Sizing Agent on the Properties of a Basalt Fiber and Epoxy Resin Composite Material
A Comprehensive Study of the Effect of Lubricant in the Sizing Agent on the Properties of a Basalt Fiber and Epoxy Resin Composite Material Open
Based on the formula for the sizing agent for basalt fiber, this paper presents a comprehensive study of the effects of lubricants on the properties of sizing agents, basalt fiber, and epoxy resin composite materials. Through testing and a…
View article: Regulation of nanosized retained-austenite morphology making low alloy ultrahigh strength steel tough
Regulation of nanosized retained-austenite morphology making low alloy ultrahigh strength steel tough Open
View article: A Study on the Mechanism by Which Graphene Oxide Affects the Macroscopic Properties and Microstructure of Abrasion-Resistant Ultra-High-Performance Concrete (UHPC)
A Study on the Mechanism by Which Graphene Oxide Affects the Macroscopic Properties and Microstructure of Abrasion-Resistant Ultra-High-Performance Concrete (UHPC) Open
To further enhance the abrasion resistance of UHPC in demanding abrasion environments, this study investigated the effects of graphene oxide (GO) on the workability, mechanical properties, and abrasion resistance of UHPC. Utilizing 27Al Nu…
View article: Effects of intercritical annealing time on microstructure, tensile properties, and cryogenic toughness of newly designed ultra-low C low Ni Medium-Mn steel
Effects of intercritical annealing time on microstructure, tensile properties, and cryogenic toughness of newly designed ultra-low C low Ni Medium-Mn steel Open
An ultra-low carbon and low nickel medium manganese heavy steel plates was fabricated by quenching and intercritical annealing process. The effect of annealing time on the tensile properties and impact toughness were studied in relation to…
View article: Study on Emergency Plugging Mechanism after Bop Seal Failure Under Uhp Blowout Conditions in Natural Gas Wells
Study on Emergency Plugging Mechanism after Bop Seal Failure Under Uhp Blowout Conditions in Natural Gas Wells Open
View article: Fine-grained dual-phase steels fabricated via cold-rolling ferrite-martensite structure and subsequent intercritical annealing
Fine-grained dual-phase steels fabricated via cold-rolling ferrite-martensite structure and subsequent intercritical annealing Open
A proposed alternative method for processing dual phase (DP) steels is the utilization of a cold-rolled duplex ferrite-martensite structure, followed by intercritical annealing. The obtained results demonstrate the feasibility of this appr…
View article: Comparative study on effects of annealing temperature on microstructures and mechanical properties of high-Al low-Si steel
Comparative study on effects of annealing temperature on microstructures and mechanical properties of high-Al low-Si steel Open
We elucidate here profound effects of quenching and partitioning process after partial (IQP) or full austenitization (FQP) on the microstructure and mechanical properties of high strength hot-dip galvanized steel with high Al and low Si co…
View article: Mechanical properties and corrosion resistance of high performance fiber-reinforced concrete with steel or amorphous alloy fibers
Mechanical properties and corrosion resistance of high performance fiber-reinforced concrete with steel or amorphous alloy fibers Open
In the present study, steel fiber and amorphous alloy fiber were applied either single-added or hybrid-added to produce high performance fiber-reinforced concrete (HPC). The results showed that the flowability of fresh concrete was reduced…
View article: Microstructure and mechanical property relationship in a high strength high-Al low-Si hot-dip galvanized steel under quenching and partitioning process
Microstructure and mechanical property relationship in a high strength high-Al low-Si hot-dip galvanized steel under quenching and partitioning process Open
We elucidate here profound effects of quenching and partitioning process on the microstructure and mechanical properties of high strength hot-dip galvanized steel with high Al and low Si content. The results indicated that partitioning tim…
View article: Corrosion response of zinc phosphate conversion coating on steel fibers for concrete applications
Corrosion response of zinc phosphate conversion coating on steel fibers for concrete applications Open
In the present study, a zinc phosphate conversion coating was successfully deposited onto steel fiber surface to improve the corrosion resistance of steel fiber reinforced concrete. An understanding of phosphating temperature–coating prope…
View article: Hydration Kinetics of Portland Cement–Silica Fume Binary System at Low Temperature
Hydration Kinetics of Portland Cement–Silica Fume Binary System at Low Temperature Open
Portland cement–silica fume binary cementitious materials are widely used in engineering construction and have been investigated from micro- to macroscopic aspects. However, the theoretical background on the hydration kinetics of the binar…
View article: Effect of higher heating rate during continuous annealing on microstructure and mechanical properties of cold-rolled 590 MPa dual-phase steel
Effect of higher heating rate during continuous annealing on microstructure and mechanical properties of cold-rolled 590 MPa dual-phase steel Open
In this presentation, the effect of higher heating rate in continuous annealing on microstructure and mechanical properties of a cold-rolled 590 MPa ferrite-martensite dual-phase steel were investigated by using microstructural observation…