Silicone resin
View article
Silicone/Ag@SiO<sub>2</sub>core–shell nanocomposite as a self-cleaning antifouling coating material Open
The effects of Ag@SiO2core–shell nanofiller dispersion and micro-nano binary structure on the fouling release of silicone paints were studied. An ultrahydrophobic PDMS/Ag@SiO2core–shell nanocomposite was prepared as an antifouling coating …
View article
Pottery‐Inspired Flexible Fire‐Shielding Ceramifiable Silicone Foams for Exceptional Long‐Term Thermal Protection Open
Owing to their preeminent properties, including mechanical flexibility, thermal insulation, and low cost, silicone foams are widely used in industrial fields. However, flame‐induced structural failure greatly restricts their practical appl…
View article
Facile Approach to Recycling Highly Cross-Linked Thermoset Silicone Resins under Ambient Conditions Open
Silicone resins are traditional thermoset polymers with an inorganic backbone, affording chemical inertness and high thermal stability, which also makes them inherently difficult to recycle by traditional methods. Here, we demonstrate that…
View article
Reduced Graphene Oxide Embedded with MQ Silicone Resin Nano-Aggregates for Silicone Rubber Composites with Enhanced Thermal Conductivity and Mechanical Performance Open
With developments of the electronics industry, more components are being included in electronic devices, which has led to challenges in thermal management. Using reduced graphene oxide embedded with MQ silicone resin (RGO/MQ) nano-aggregat…
View article
Catalyst Free Silicone Sealants That Cure Underwater Open
Silicone sealants and adhesives are widely used to prevent the ingress of water. However, silicones must normally be cured in air, as excess water inhibits or prevents cure from occurring. It is reported that aqueous solutions of the aliph…
View article
Silicone Resin-Based Intumescent Paints Open
Silicone resins are widely applied as coating materials due to their unique properties, especially those related to very good heat resistance. The most important effect on the long-term heat resistance of the coating is connected with the …
View article
Investigation of Thermostability of Modified Graphene Oxide/Methylsilicone Resin Nanocomposites Open
To promote the thermostability of methylsilicone resin, toluene-2,4-diisocyanate (TDI) modified graphene oxide (GO) was grafted on silicone resin.Fourier-transformed infrared (FT-IR) spectra suggested that modified GO was grafted on silico…
View article
Silicone Resin Polymer Used in Preventive Maintenance of Asphalt Mixture Based on Fog Seal Open
The commonly used materials in fog seal are emulsified asphalt and modified emulsified asphalt. Nevertheless, there are some intractable problems including aging under ultraviolet, poor permeability, and moisture susceptibility. Therefore,…
View article
A Simple Preparation Route for Bio-Phenol MQ Silicone Resin via the Hydrosilylation Method and its Autonomic Antibacterial Property Open
MQ silicone resins represent a broad range of hydrolytic condensation products of monofunctional silane (M units) and tetrafunctional silane (Q units). In this work, a Bio-Phenol MQ silicone resin (BPMQ) was designed and synthesized by the…
View article
Robust superhydrophobic silicone/epoxy functional coating with excellent chemical stability and self-cleaning ability Open
This study reports on the design and synthesis of a highly transparent fluorinated silicone resin with low surface energy, and its application in the preparation of superhydrophobic coatings with remarkable self-cleaning and robust perform…
View article
Preparation and anti-oxidation performance of Al<sub>2</sub>O<sub>3</sub>-containing TaSi<sub>2</sub>–MoSi<sub>2</sub>–borosilicate glass coating on porous SiCO ceramic composites for thermal protection Open
Al2O3improves the oxidation resistance of TaSi2–MoSi2–borosilicate glass coating through increasing the viscosity and inhibiting gas penetration into matrix at high temperature, thus prevents porous SiCO ceramic composites from being oxidi…
View article
Suppression Effect and Mechanism of Amine-Containing MQ Silicone Resin on the Tracking and Erosion Resistance of Silicone Rubber Open
How to effectively enhance the antitracking performance of silicone rubber is a huge challenge in the field of high-voltage insulation. In this contribution, amine-containing MQ silicone resin (A-MQ) was prepared to enhance the tracking an…
View article
Study on the Synthesis and Thermal Stability of Silicone Resin Containing Trifluorovinyl Ether Groups Open
Silicone resin is a high-temperature resistant material with excellent performance. The improvement of its thermal stability has always been the pursuit of researchers. In this paper, a sequence of silicone resins containing trifluorovinyl…
View article
Glass powders and reactive silicone binder: Interactions and application to additive manufacturing of bioactive glass-ceramic scaffolds Open
A novel concept for the additive manufacturing of three-dimensional glass-ceramic scaffolds, to be used for tissue engineering applications, was based on fine glass powders mixed with a reactive binder, in the form of a commercial silicone…
View article
Spectroscopic Signatures of MQ-Resins in Silicone Elastomers Open
Polysiloxane elastomers have a large application space due to their versatile cross-linking chemistry and highly tunable physical and mechanical properties. One approach for improving the mechanical integrity of commercial polysiloxane “si…
View article
Hygrothermal Aging Characteristics of Silicone-Modified Aging-Resistant Epoxy Resin Insulating Material Open
To study the improvement effect of silicone materials on the hygrothermal resistance of epoxy resin and the aging mechanism of silicone-modified insulation materials under hygrothermal conditions, diphenylsilanediol was added to epoxy resi…
View article
Performance Enhancement of Permeable Asphalt Mixtures With Recycled Aggregate for Concrete Pavement Application Open
The incorporation of recycled concrete aggregate (RCA) in permeable asphalt mixtures (PAMs) is an efficient method of utilizing construction demolished waste. It not only conforms to the trend of building sponge cities, but also alleviates…
View article
High Moisture Accelerated Mechanical Behavior Degradation of Phosphor/Silicone Composites Used in White Light-Emitting Diodes Open
In a high-power white light emitting diode (LED) package, the phosphor/silicone composite is typically used for photometric and colorimetric conversions, ultimately producing the white light. However, the phosphor/silicone composite is alw…
View article
IPN Polysiloxane-Epoxy Resin for High Temperature Coatings: Structure Effects on Layer Performance after 450 °C Treatment Open
Coatings for high temperatures (HT > 400 °C) are obtained from interpenetrating polymer network (IPN) binders formed by simultaneous polymerization of silicone and epoxide pre-polymers. A ceramic layer; mainly composed of silica and filler…
View article
PLA and two components silicon rubber blends aiming for frozen foods packaging applications Open
Designing of PLA and two components silicone rubber blends was studies. Frozen food packaging application is the main ultimate aim. The statistical method using 23 DOE was conducted. The standard testing methods, in particular impact testi…
View article
Lubricated PDMS-bearing ladderlike polysilsesquioxane coating: Fabrication and factors governing its long-term ice-shedding performance Open
Reacting an epoxy-bearing ladder-like polysilsesquioxane (LASQ) with mono-carboxy-terminated poly(dimethyl siloxane) (PDMS-COOH) yields LASQ-PDMS, a blend of LASQ and a graft (g) copolymer LASQ-g-PDMS. Photolyzing a cast film of LASQ-PDMS …
View article
Silicone oil impregnated nano silica modified glass surface and influence of environmental dust particles on optical transmittance Open
The behavior of environmental dust particles on a silicone oil impregnated glass surface is examined in relation to optical transparent surfaces for self-cleaning applications.
View article
Uncover the Degradation Science of Silicone Under the Combined Temperature and Humidity Conditions Open
In this paper, we report the mechanistic insights into thermal and humidity induced degradation of silicone employed in high power LEDs. High power blue and white light emitting diodes (LEDs) are used for experimentation. The silicone enca…
View article
Mechanically Enhanced Self-Stratified Acrylic/Silicone Antifouling Coatings Open
Great attention has been paid to silicone-based fouling-release coatings (FRCs) in the realm of maritime antifouling due to their highly efficient and eco-friendly properties, but many challenges remain for developing a silicone-based FRC …
View article
Effect of cenospheric fillers on the flammability and fire hazard of silicone rubber composites Open
This paper presents the results of testing the flammability of silicone rubber composites containing fillers, such as cenospheres, cenospheres covered with iron, attapulgite, wollastonite, aluminum hydroxide and silica. In order to increas…
View article
Polymer-Derived Biosilicate®-like Glass-Ceramics: Engineering of Formulations and Additive Manufacturing of Three-Dimensional Scaffolds Open
Silicone resins, filled with phosphates and other oxide fillers, yield upon firing in air at 1100 °C, a product resembling Biosilicate® glass-ceramics, one of the most promising systems for tissue engineering applications. The process requ…
View article
Impact of Basalt Filler on Thermal and Mechanical Properties, as Well as Fire Hazard, of Silicone Rubber Composites, Including Ceramizable Composites Open
This article illustrates the impact of basalt filler, both in the form of basalt flakes and basalt fibers, on thermal and mechanical properties, as well as on the fire hazard, of silicone rubber (SR) composites, including ceramizable compo…
View article
Enhanced Heat Resistance of Acrylic Pressure-Sensitive Adhesive by Incorporating Silicone Blocks Using Silicone-Based Macro-Azo-Initiator Open
To improve the heat resistance of acrylic-based pressure-sensitive adhesive (PSA), silicone-block-containing acrylic PSAs (SPSAs) were synthesized using a polydimethylsiloxane (PDMS)-based macro-azo-initiator (MAI). To evaluate the heat re…
View article
Ceramifiable and mechanical properties of silicone rubber foam composite with frit and high silica glass fiber Open
In this paper, ceramifiable silicone rubber foam composite was prepared by silicone rubber, fumed SiO2, talc, frit, high silica glass fiber, foaming and vulcanizing agents. Thermal property, micromorphology, phase transformation and compre…
View article
Study on the Superhydrophobic Properties of an Epoxy Resin-Hydrogenated Silicone Oil Bulk Material Prepared by Sol-Gel Methods Open
A superhydrophobic material was prepared by a simple and easily accessed sol-gel method using epoxy resin (E-51) and γ-aminopropyltriethoxysilane (KH-550) as the precursors, aqueous ammonia (NH4OH) as the catalyst and hydrogenated silicone…